IP issue and setup

From ETC Public Wiki
Jump to: navigation, search

Since Vision Processor (OM box) is connected via Ethernet cable, any windows station should have a secondary internet card with it.


Here's how to config IP address if you are putting in a new windows station.

1. Connect the Ethernet cable to both the Vision processor and the windows station. (To the secondary Ethernet card, not from motherboard port)
2. Go to Start --> Control Panel --> Network and Internet --> Network and Sharing Center
3. Click on Mocap Lan. Then at popup window called "Mocap Lan", click on Properties. (If ask for permission to continue, just key in ANDREW\Your andrew ID for User name. And your password for that Andrew ID.)
4. Select Internet Protocal Version 4 (TCP/IPv4), and click on Properties. Then a window will popup just like this.

Ipv4.PNG

5.Make sure both radio buttons set to Use the following IP address and Use the following DNS server address.
6.IP address can be anything in between 192.168.1.1 to 192.168.1.255, Subnet mask set to 255.255.255.0. And Default gateway should be set to 192.168.1.1.